WOODLOK 2400 is a premium grade, sandable Aliphatic Resin. The bonds formed are heat and moisture resistant and the glue line will accept stains and lacquers. Formulated to provide high strength bonds with minimal creep on softwoods and hardwoods. Fast wet tack, is quick drying and has excellent machining and sanding properties.
COMMON USES
WOODLOK 2400 is suitable for edge and face gluing, laminating and general assembly work. Good for furniture manufacture where a very smooth finish is required.
BONDS Hardwoods and softwoods
ADVANTAGES
Fast wet tack and cure times.
Can be used down to 5°C.
Minimal creep.
Hard, sandable glueline, gives a very clean final appearance.
PROPERTIES
Chemical Description : Aliphatic Resin Emulsion.
PREPARATION All surfaces to be glued must be clean and dry. Remove all oil, grease, wax, old glue, finish or other foreign material before gluing. Generally, wood requires no special preliminary treatment, however, the most efficient bonds develop when the wood has been resurfaced just prior to applying glue with sharp blades.
TECHNICAL DETAILS
Viscosity : 8,000cps
Solids : 48%
Open Time @ 20°C : 5min
Base : PVA
APPLICATION METHOD For best results, temperatures should be above 15°C for both the work area and the stock being used. Best bonds are obtained when moisture content ranges between 8% and 12%.
APPEARANCE
Tan liquid
ODOUR Slight PVA when wet. None when dry.
CLEAN UP Water whilst wet. Cured glue must be cut, scraped or sanded away.
COVERAGE
120gm—240gm m² of glue line is recommended depending on substrate.
Login
COMMON USES
- WOODLOK 2400 is suitable for edge and face gluing, laminating and general assembly work. Good for furniture manufacture where a very smooth finish is required.
BONDSHardwoods and softwoods
ADVANTAGES
- Fast wet tack and cure times.
- Can be used down to 5°C.
- Minimal creep.
- Hard, sandable glueline, gives a very clean final appearance.
PROPERTIES- Chemical Description : Aliphatic Resin Emulsion.
PREPARATIONAll surfaces to be glued must be clean and dry. Remove all oil, grease, wax, old glue, finish or other foreign material before gluing. Generally, wood requires no special preliminary treatment, however, the most efficient bonds develop when the wood has been resurfaced just prior to applying glue with sharp blades.
TECHNICAL DETAILS
- Viscosity : 8,000cps
- Solids : 48%
- Open Time @ 20°C : 5min
- Base : PVA
APPLICATION METHODFor best results, temperatures should be above 15°C for both the work area and the stock being used. Best bonds are obtained when moisture content ranges between 8% and 12%.
APPEARANCE
- Tan liquid
ODOURSlight PVA when wet. None when dry.
CLEAN UP
Water whilst wet. Cured glue must be cut, scraped or sanded away.
COVERAGE
SIZES